mayphly Posted January 25, 2015 Report Share Posted January 25, 2015 So I was browsing the WWW looking for ways of stabalizing temps in tanks and stumbled across this video from Jacob's Aquarium which I thought I'd share. It's a great way to maximize the efficiencey of your heater and save some $$$ if your heating a lot of tanks. SurraGync 1 Quote Link to comment Share on other sites More sharing options...
Jadenlea Posted January 25, 2015 Report Share Posted January 25, 2015 huh. never thought about it but it makes sense. Quote Link to comment Share on other sites More sharing options...
Ron Posted January 25, 2015 Report Share Posted January 25, 2015 Not a problem for me, the only heaters I have currenly in use are Hydor inline heaters. I do have a couple Fluval heaters with the digital display and it would indicate an error when it detected low flow. Quote Link to comment Share on other sites More sharing options...
jumpsmasher Posted January 26, 2015 Report Share Posted January 26, 2015 I use the ViaAqua titanium heaters with external temperature controller / sensor and am really liking them. The titanium heating rod is located behind my HMF and sensor is located about 10 inches away in the middle of the tank. Don't think I am going back to standard heaters; there digital read out is super reading to set and it also tells you the current temperature of your water Quote Link to comment Share on other sites More sharing options...
Dendrobatez Posted January 26, 2015 Report Share Posted January 26, 2015 I usually have my heaters either in the filter (my preference) or under the outflow of the filter. I don't typically go over board on heaters though because my house is usually at 75 so they don't spend too much time on. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.